On the back of the unit 2 to 3 times

Connecting Wireless Rear Speakers

ENG

Resetting Wireless Communication

1Connect your pair of wireless rear speakers, (L) and (R), to the wireless receiver module.

2Connect the power cord of the wireless receiver module to the wall outlet and turn the power "ON".

• The Power Standby indicator will light up.

Reset the system if a communication failure occurs, or if the synchronizing signal indicator does not light up and the "REAR CHK" message blinks on the main unit's display.

Reset the system while the main unit and the wireless receiver module (SWA-2000) are in Power Standby mode.

Wireless Rear Speaker (R)

Wireless Rear Speaker (L)

GrayBlue

Back of Wireless receiver module

Caution

1 With the main unit turned off, press and hold the remote control's REMAIN button for 4 seconds.

•Press the button until the volume control indicator lights up blue. (The indicator will turn off in 1 second.)

2 With the wireless receiver module turned on, use a ball point pen or a pair of tweezers to press the RESET button

RESET Button

Back of Wireless receiver module

CONNECTIONS

•Do not connect the wireless rear speakers to the speaker outputs on the back of the main unit. Malfunction may result.

•The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and moisture.

•For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.

To hang the wireless receiver module on the wall,

on the back of the unit 2 to 3 times.

•The Standby/On LED on the front panel of the wireless receiver module blinks 3 times.

3 Turn on the main unit.

• The Link LED of the wireless receiver module is lit and the setup is finished.

• If Power Standby mode continues, repeat Steps 1 to 3 above.

1Separate wireless receiver module stand.

3 Fix the wireless receiver

Fit the speaker

module	hole onto the screw
on the wall.	on the wall to hang
on the wall.	(mount) the speaker.

• Fix the wireless receiver module firmly to prevent it from falling.

2Fasten the screws on the wall.

Note

•Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the main unit, some sound interruption may be heard due to interference.

•If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same frequency (2.4GHz) near the system, some sound interruption may be heard due to interference.

•The transmission distance of radio wave is about 33 feet, but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the system may not operate at all because the radio wave cannot penetrate metal.

Caution

•Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro Logic II mode only.

•In 2-CH mode, no sound will be heard from the wireless rear speakers.