Resetting Wireless Communication

Connecting the optional Wireless Receiving Amplifier

To connect the rear speakers wirelessly, you have to additionally purchase the wireless receiving module and TX card from your product provider.

Front Speaker (R)

Front Speaker (L)

Center Speaker

Subwoofer

Rear Speaker (L)	WIRELESS RECEIVER MODULE	Rear Speaker (R)

ENG

When you have purchased the wireless receiving module (SWA-3000)

Reset the system if a communication failure occurs, or if the Link indicator (blue LED) on the wireless receiver does not light up and the "REAR CHK" message blinks on the main unit's display.

Reset the system while the main unit and the wireless receiver module (SWA-3000) are in Power Standby mode.

1	With the main unit turned off, press and
	hold the remote control's REMAIN button
	for 5 seconds.	CONNECTIONS
2 turned on, use a ball point pen or a pair		CONNECTIONS
	• Press the button until the POWER( ) indicator lights
	up blue. (The indicator will turn off in 1 second.)
	With the wireless receiver module
	of tweezers to press the RESET button	WIRELESS RECEIVER MODULE
	on the back of the unit.

•The Standby/On LED on the front panel of the

wireless receiver module blinks 2 times.

Connect the front, center and

subwoofer speakers, referring to page 12.

Insert the TX card into the TX card connection port on the back of the main unit.

•Hold the TX card so that the slanted side faces left- ward and insert the card into the port.

SPEAKERS OUT (IMPEDANCE 3§)

	XM	WIRELESS
XM	WIRELESS

COMPONENT

OUT

PB HDMI OU

3 Turn on the main unit.

• The Link LED of the wireless receiver module is lit and the setup is finished.

• If Power Standby mode continues, repeat Steps 1 to 3 above.

Caution

•The TX card enables communication between the

main unit and the wireless receiver.

3	Connect the left and right rear	TX card
3	Connect the left and right rear
	speakers to the wireless receiving
	module.
4	Plug the power cord of the wireless
	receiving module in the wall outlet and
	switch the power switch ‘ON’.

Caution

•Do not insert a card other than the TX card dedicated for the product. The product might be damaged or it may not be removed easily.

•Do not insert the TX card upside down or in reverse direction.

•Insert the TX card when the main unit is turned off.Inserting the card when it is turned on may cause a problem.

•If the TX Card is inserted in the main unit, the rear speakers don't output sounds.

• When the wireless receiving module setting is complete, no audio signal is output from the Rear Speaker OUT ports on the back

of the main unit.

• The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and moisture.

• For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstruc-

tions.

• Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro Logic II mode only.

• In 2-CH mode, no sound will be heard from the wireless rear speakers.

Note

• Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the main

unit, some sound interruption may be heard due to interference.

• If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same

frequency (2.4GHz) near the system, some sound interruption may be heard due to interference.

• The transmission distance of radio wave is about 33 feet, but may vary depending on your operating environment.

If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the system may not operate at

all, because the radio wave cannot penetrate metal.

Connecting the optional Wireless Receiving Amplifier