Feature | Implementation | Values |
| |
Media Source | <</MediaPosition int>> setpagedevice | Where int is one of the following: | ||
|
| 0 | = | Auto Select |
|
| 1 | = | Tray 1 |
|
| 2 | = | Tray 2 |
|
| 3 | = | Tray 3 (High Capacity) |
|
| 4 | = | Tray 4 (High Capacity) |
|
| 5 | = | Bypass Tray (SMH) |
|
| NOTE: See the media selection comments in | ||
|
| the Dependencies / Caveats section. | ||
Output Location – | << /OutputType (string) >> setpagedevice | Where string can be one of the following: | ||
options supported |
| When a catch tray is installed: | ||
depend on output | OR | SideTray |
| |
device. |
| When a 2000 Sheet Stapler Stacker (Office | ||
| %%OID_ATT_OUTPUT_BINS value | Finisher) is installed: | ||
|
| TopTray |
| |
|
| Stacker |
| |
|
| Where value can one of the following: | ||
|
| OID_VAL_OUTPUT_BIN_TOP or | ||
|
| OID_VAL_OUTPUT_BIN_SIDE | ||
|
| OID_VAL_OUTPUT_BIN_STACKER | ||
|
| NOTE: You cannot use the finisher stacker tray | ||
|
| with envelopes and labels. Stapling or punching | ||
|
| requires use of the stacker tray. If you indicate an | ||
|
| invalid combination of commands, the output | ||
|
| location request is ignored. | ||
Stapling | <</Staple int | Where int is one of the following: | ||
| <</StapleDetails<</Type1/StapleLocation | 0 = No Staple | ||
| (string)>> | 3 = Staple at the end of set | ||
| >> | Where string is one of the following three values: | ||
| >>setpagedevice | |||
|
| SinglePortrait - for single staple in portrait | ||
|
| documents. |
| |
|
| SingleLandscape - for single staple in Landscape | ||
|
| documents |
| |
|
| DualLandscape - two staples | ||
|
| NOTE: Refer to the "Single Staple Location" table | ||
|
| later in this document, for information about | ||
|
| staple location restrictions. | ||
Hole Punching | << /Punch int | Where int is one of the following: | ||
| /PunchDetails << /Type 6 | 0 = No Punch | ||
| /NumHoles 1 >> >> setpagedevice | 4 = Punch each page | ||
|
| NOTE: You can use the hole punching | ||
|
| command with 8.5 x 11", 11 x 17", 9 x 11", A4, | ||
|
| A3 and A4 cover size media only. Use the | ||
|
| "rotated landscape" orientation with 11 x 17" | ||
|
| and A3 pages. | ||
|
|
| ||
Collation | <</Collate value>> setpagedevice | Where value is one of the following: | ||
|
| true = Collated | ||
|
| false = Uncollated |
dc02cc0304
Document Centre Technical Support Operations | Page 5 |