Troubleshooting
Symptom |
| Check | Remedy |
|
|
|
|
Can't select Dolby Pro | • | Is the input signal selected properly? | • Only 2 channel signal can select |
Logic IIx mode. |
|
| Dolby Pro Logic IIx mode. (ex:Dolby |
|
|
| Digital, PCM, 2 channel analog input |
|
|
| signal.) |
Can't select NEO:6 mode. | • Is the input signal selected properly? | • Use PCM and Analog input signal. | |
|
|
|
|
There is no sound when | • | Is Digital input selected? | • Check whether the DVD player is |
playing a DTS encoded |
|
| properly connected and refer to |
DVD. |
|
| page 29 to select the digital input. |
Product protection function
Heat protection
•The protection function will come on if the main unit or power transformer overheats.
" 
" will appear in the display .
This function will come on :
-If speaker terminal is shorted
-If speaker cable is shorted
If there is no problem when you turn the unit on again after turning it off, PROTECTION mark will disappear on the display and the unit will work properly.
M If PROTECTION appears on the display, check whether the speaker terminal is shorted and then turn on the unit again.
ASC Error List
Error No. | VFD Message | Action | |
|
|
| |
E01 | HP CONCT | Disconnect the headphones. | |
E02 | NO MIC | Connect the microphone. | |
|
|
| |
E03 | NOISY | Take an appropriate action to reduce the surrounding noise. | |
|
|
| |
E04 | MIC LEVL | The speaker is too close to the microphone. | |
Check the distance between speaker and microphone. | |||
|
| ||
E05 | NO FRONT | Check if the front speaker is connected properly. | |
E07 | LEVL OVR | Check the position of each of speaker and microphone. | |
|
|
| |
E08 | DIST OVR | The distance between speaker and microphone exceeds the acceptable value. | |
Check the location of microphone and each speaker. | |||
|
| ||
E13 | TIME OVR | Unplug the power cable and plug it back. | |
Then, perform ASC again. | |||
|
| ||
E14 | CODE ERR | Unplug the power cable and plug it back. | |
Then, perform ASC again. | |||
|
|
56