Belkin F5D7001 Performing Diagnostic Tests on your Connection, Click on the Diagnostics tab

Page 38

Using the Belkin Wireless LAN Utility

Performing Diagnostic Tests on your Connection

Click on the “Diagnostics” tab.

This page allows you to perform several diagnostic tests that are available for your Belkin Wireless G Desktop Network Card.

Control Registers

This test verifies the read and write capabilities of the network controller registers by writing various values to the registers and verifying the result. The device driver uses these registers to perform network functions such as sending and receiving information. If the test fails, the network adapter may not work properly.

SPROM Format Version

This test verifies the content of the SPROM by reading a portion of the SPROM and computing the checksum. The test fails if the computed checksum is different than the checksum stored in the SPROM.

Memory Tests

This tests verifies that the network controller internal memory is functioning properly. The test writes patterned values to the memory and reading back the results. The test fails if an erroneous value is read back. The network controller will not function without its internal memory.

36

Image 38

Contents High-Speed Mode Wireless G Desktop Network Card Table of Contents Introduction Introduction Cordless Phone Placement Avoid Obstacles and InterferenceChoose the quietest channel for your wireless network Secure connections, VPNs, and AOLIntroduction Product Features OverviewCompatibility with 802.11b products Connection rates of up to 54Mbps or 125Mbps* using HSMDifficult-to-wire environments Frequently changing environmentsActivity LED green Card ConnectorDetachable Antenna Product Specifications Link LED orangePackage Contents System RequirementsInstalling and Setting Up the Card Install the SoftwareInsert the Card into the Computer Installing and Setting Up the Card Let Windows Finish the Installation Installing and Setting Up the Card Installation is now complete Available Networks Setting Wireless Network PreferencesClick on the Wireless Networks tab Enable Radio System Tray Icon Preferred NetworksAdd, Remove PropertiesComputer-to-Computer Ad-Hoc Networks Only Any Available Network Access Point PreferredAccess Point Infrastructure Networks Only Securing your Wi-FiNetwork Encryption Keys WEP Wired Equivalent PrivacyBit WEP WPA Wi-Fi Protected Access C3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP keyUsing a Hexadecimal Key Changing the Wireless Security Settings WEP Setup Bit WEP EncryptionC3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP key WPA-PSK no server WPA with server Settings Using the Belkin Wireless LAN Utility Type your WEP key in the Network key box Using the Belkin Wireless LAN Utility Using the Belkin Wireless LAN Utility Monitoring the Status of your Network Connection Network Connection Type SignalClient IP Address Radio StateMonitoring Data Transfer Click on the Statistics tabFinding Available Networks in your Area Control Registers Performing Diagnostic Tests on your ConnectionClick on the Diagnostics tab Sprom Format VersionLED Test Interrupt TestLoopback Test Troubleshooting Can’t connect to the Internet wirelesslyName of your wireless network appears in Available Networks Installation CD-ROM does not start Setup Utility Power LED does not come on Card is not workingLink LED is solid but cannot connect to the Internet Signal strength is poor Data transfer is sometimes slowTroubleshooting Wireless PCI Card is not Detected by Operating System Wireless Comparison What’s the difference between 802.11b, 802.11g and 802.11a?Technical Support Europe 00 800 223 55 Australia 1800 666FCC Statement Federal Communications Commission NoticeInformation Belkin Corporation Limited Lifetime Product Warranty Belkin Tech Support

Related manuals

Manual 52 pages 23.2 Kb