Belkin F1D5102P, F1DS104T, F1DS102T Using Your Soho Series KVM Switch, Powering up the Systems

USB INSTALLATION

COMPUTER:

9.Using the audio cable, connect one end of the male 3.5mm plug to the SPEAKER OUT jack of your sound card or computer and connect the other end to the SPEAKER IN jack of your SOHO Series KVM Switch. See fig. 14.

fig. 14

10.Using a second audio cable, connect one end of the male 3.5mm plug to the MIC OUT jack of your sound card or computer and connect the other end to the MIC IN jack of your OmniView SOHO Series KVM Switch. See fig. 14.

USING YOUR SOHO SERIES KVM SWITCH

Powering up the Systems

Once all cables have been connected, power up the CPUs that are attached to the SOHO Series KVM Switch. All computers can be powered on simultaneously. The SOHO Series KVM Switch emulates a mouse and keyboard on each port and allows your computer to boot normally.

Your Belkin SOHO Series KVM Switch should now be ready for use.

You can select which computer to operate by either the push-button Selector Button located on the front panel of the SOHO Series KVM Switch or through keyboard hot key commands. Note that it will take 1–2 seconds for the video to display after switching. This is due to the refresh of the video signal. There is also re-synchronization of the mouse and keyboard signal that takes place. This is normal operation and ensures that proper synchronization is established.

Selecting a Computer Using Front-Panel Selector Buttons

You can directly select which computer you wish to control by pressing the corresponding push button next to the appropriate port. The LED will be lit to indicate that the port is currently selected.

Selecting a Computer Using Keyboard Hot Key Commands

You can command the SOHO Series KVM Switch to switch ports with a simple keyboard command sequence by using the [SCROLL LOCK] key and [UP], [DOWN] arrow keys. To send commands to the SOHO Series KVM Switch, the [SCROLL LOCK] key must be pressed twice within two seconds. You will hear a beep for confirmation. Then you can press the [UP], [DOWN] arrow keys to switch between ports.

Switch to next active port,	Switch to previous active port,
[UP] arrow	[DOWN] arrow

20 21