Belkin F1DS104P, F1D5102P PS/2 Installation, Step-by-Step Installation Guide, Important Note

INSTALLATION

Step-by-Step Installation Guide

This section provides complete instructions for the hardware setup of a single SOHO Series KVM Switch. (F1DS102P, F1DS104P, F1DS102T, or F1DS104T)

Important Note:

Before attempting to connect anything to the SOHO Series KVM Switch or into your computer(s), make sure that everything is powered off. Plugging and unplugging cables while computers are powered on may cause irreversible damage to the computers and KVM Switch. Belkin Components will not be responsible for damage caused by these actions.

Installing the SOHO Series KVM Base:

Hold the main housing with one hand and the base with the other.

With the narrow part of the base facing towards the rear of the housing, align the hooks of the base to the base holes located underneath the housing. Put the hooks through the holes and push the base toward the front of the housing to lock the base into place. See fig. 3.

fig. 3

PS/2 INSTALLATION

PS/2 Installation:

Keyboard, Video, and Mouse Connections

CONNECT THE
CONSOLE:
1.	Connect the
	monitor to the
	SOHO Series
	KVM Switch.
	Using the cable
	that is included
	with your monitor, connect it to
	the HDDB15 female port on the top of
	the SOHO Series KVM Switch with the
	monitor symbol on the console. See fig. 4.
2.	Connect a PS/2 keyboard to the PURPLE port on	fig. 4
	the console. See fig. 5.

3.Connect a PS/2 mouse to the GREEN port on the console. See fig. 5

fig. 5

10 11