Belkin F1DA104T user manual Installation, Before You Begin, Adding Additional Slave Units

Page 16

I N STA L L AT I O N

Installation

Before You Begin:

1.Make sure that all computers are powered off and that each PRO2 has been assigned a unique BANK address.

2.Place Master and Slave switches in the desired location. Make sure all are turned off and unplugged from the power source.

3.Connect the Console monitor, keyboard, and mouse to the Console ports of the Master switch or Bank 00, as described previously in this installation guide.

Connecting the Master Switch to the First Slave Switch:

4.Using the daisy-chain cable (F1D108-CBL), connect one end of the cable to the “Master Input/Slave Output” port on the Master switch (BANK 00).

5.Connect the other end of the daisy-chain cable to the “Master Input/Slave Output” port of the first Slave switch (BANK 01).

Adding Additional Slave Units:

6.Using the daisy-chain cable (F1D108-CBL), connect one end of the cable to the available daisy-chain port labeled “Slave Input” on the Slave switch (for example, BANK 01).

7.Connect the other end of the daisy-chain cable to the “Master Input/Slave Output” port of the Slave switch that you are adding

(for example, BANK 02).

8.Repeat steps 6 and 7 for additional PRO2s you wish to daisy-chain together.

14

Image 16

Contents OmniView TA B L E O F C O N T E N T S OverviewPackage Contents OmniViewFeature Overview E RV I E WEquipment Requirements Front-Panel Push ButtonLED Display Seven-Segment LED DisplayOperating Systems Side View of the PRO2 Front View of the PRO2 Back View of the PRO2Specifications Max. Resolution 2048x1536@85Hz Bandwidth 400MHzSTA L L AT I O N Pre-ConfigurationCable Distance Requirements Installing the PRO2 into a Server Rack Step-by-Step Installation GuideBracket Installation F1DA108T and F1DA116T only Single PRO2 Installation Connect the Computer PS/2 Installation USB InstallationConnecting Multiple PRO2s Daisy-Chaining USB cablesBank DIP Switch Configuration Chart DIP SWITCH#Installation Connecting the Master Switch to the First Slave SwitchBefore You Begin Adding Additional Slave UnitsExample of Daisy-Chain Configuration Connecting the ComputersPowering up the Systems Using Your PRO2Selecting a Computer Using Keyboard Hot Key Commands + +AutoScan Mode Selecting a Computer Using Direct-Access Port SelectorsI N G YO U R K V M SW I T C H Bank Up and Bank Down Scroll ButtonsKeyboard Hot Key Commands On-Screen Display Menu Control To update the firmware, you will need the following items AutoScan TimeOSD Display Time Updating FirmwareConnecting Computers Setting the PRO2 into Flash ModeBelkin KVM Switches and Accessories OmniView KVM SwitchesMATRIX2 OmniView All-In-One KVM Cables USBOmniView Accessories and Adapters PRO2 Series FAQs PRO2 Series FAQs PRO2 Series FAQs General TroubleshootingVideo Keyboard MouseMouse is not detected at boot-up USB WARRANTY, FCC , CE, Ices Statement F1DA104T, F1DA108T, F1DA116TP73782-A