Using Your Switch, Hot Key Commands | Belkin F1DZ102T, F1DZ104T

USING YOUR SWITCH

Select connected computers by either the direct-access port-selectors, located on the front panel of the Switch, or hot key commands, through the console keyboard. It takes approximately 1-2 seconds for the video signal to refresh after switching computers. Re-synchronization of the mouse and keyboard signals also occurs. This is normal operation and ensures that proper synchronization is established between the console and the connected computers.

Selecting a Computer Using Direct-Access Port-Selectors

You can directly select which computer you wish to control by pressing the direct-access port-selector next to the corresponding port. The LED will illuminate to indicate the port is currently selected. If you are installing multiple switches that are daisy-chained, use the BANK scroll keys located on the front panel of the Master switch to access other computers that are connected to the Slave switches. Pressing both buttons simultaneously will reset the Switch.

Selecting a Computer Using Keyboard Hot Key Commands

Switch to the next or prior port with simple keyboard key sequences using the Scroll Lock key and either the up or down arrow keys. To send commands to the Switch, the Scroll Lock key must be pressed twice within two seconds. The Switch will beep, confirming that it is in hot key mode. Next, press the up or down arrow keys, and the Switch will switch to the prior port or the next port.

Switch to next active port,	Switch to previous active port,
down arrow	up arrow

USING YOUR SWITCH

You can switch directly to any port by entering the two-digit BANK address followed by the two-digit number of the port you wish to access. For example, if you press “Scroll Lock”, “Scroll Lock”, “00”, “02”, the Switch will switch to the computer on port 2 located on BANK 00.

+ +

Switch to BANK 00, Port 2—(02)

Note: You will have approximately five seconds to complete each hot key sequence.

With daisy-chain switch configuration, you can switch between BANKs by pressing “Scroll Lock”, “Scroll Lock”, “Page Up”, to switch to the next BANK. Press “Scroll Lock”, “Scroll Lock”, “Page Down”, to switch to the previous BANK.

		+	+	Page	+	+	Page
		+	+	Up	+	+	Down
Switch to previous BANK, Page Up					Switch to previous BANK, Page Down
Hot Key Commands
SL	SL	Up Arrow			Switch to PREVIOUS ACTIVE port
SL	SL	Down Arrow			Switch to NEXT ACTIVE port
SL	SL	Page Up			Switch to PREVIOUS BANK
					(By default, selects first active port on the BANK)
SL	SL	Page Down			Switch to NEXT BANK
					(By default, selects first active port on the BANK)
SL	SL	X	Y		Directly switches to PORT Y on BANK X
					(X=00 to 03) (Y=01 to 02 for F1DZ102T)
					(X=00 to 03) (Y=01 to 04 for F1DZ104T)
SL	SL	S			Disable sound in AutoScan mode
SL	SL	A			Enable AutoScan mode
					(Refer to AutoScan button)