Step-by-Step Installation Guide

INSTALLATION

Cautions and Warnings

Before attempting to connect anything to the Switch or your computers, please ensure that all equipment is powered off. Plugging and unplugging cables while computers are powered on may cause irreversible damage to the computers and/or the Switch(es). Belkin is not responsible for damage caused in this way.

Installing the Switch into a Server Rack

Bracket Installation

The 4-Port KVM Switch can be installed into a server pack using the optional mounting kit (F1D005). Please follow these simple steps to achieve the desired adjustment.

Note: If this KVM Switch will be daisy-chained to another switch, set the BANK address prior to installing on a rack. Refer to the section in this User Manual labeled “Connecting Multiple KVM Switches (Daisy-Chaining)”.

1.Attach the bracket to your Switch.

2.Determine how far you would like the Switch to protrude from the rack. Select a bracket-hole scheme.

3.Attach the bracket to the side of your Switch with the Phillips screws provided. (Refer to diagram below.)

4.Mount the Switch to the rack rail assembly.

Your Switch is now mounted securely into the bracket and you are ready to connect cables to the back.

INSTALLATION

Single KVM Switch Installation

This section provides complete instructions for the hardware setup of a single SE Plus Series KVM Switch.

PS/2 Installation:

Keyboard, Video, and Mouse Connections

Connect the Console to the KVM Switch

1. Connect your monitor cable to the HDDB15 female port on the back of the Switch labeled "Console VGA”.

2. Connect the PS/2 keyboard cable to the keyboard port on the back of the Switch in the “Console” section.

3. Connect the PS/2 mouse cable to the mouse port on the back of the Switch in the “Console” section.

4.Attach the power supply to the connector labeled “DC 12V, 1A” located on the rear of the Switch. Once the power is connected to a power source, the LED for port 01 will begin flashing. Sequentially push the direct-access buttons for ports 01 through 04 (02 for F1DZ102T and 04 for F1DZ104T). The corresponding LED should flash as each button is pressed, indicating that the port is ready for connecting your servers (computer connection).