Connect the Computer PS/2 Installation | Belkin F1DZ104T, F1DZ102T

INSTALLATION

Connect the Computer

PS/2 Installation

1.Using an OmniView KVM Cable (F3X1105-XX or F3X1835-XX-GLD), plug in the male VGA connector to the VGA port on the computer. Connect the other end (the female connector) of the VGA cable to the back of the Switch labeled “VGA 01”.

2.Connect the PS/2

keyboard and PS/2 mouse connectors to the keyboard and mouse ports on the computer. Connect the other ends of the cables to the keyboard and mouse ports located directly underneath VGA 01 on the Switch (F3X1105-XX or F3X1835-XX-GLD).

3. Repeat steps 1 and 2 for each additional PS/2 computer you wish

to connect.

INSTALLATION

USB Installation

Boot the computer you wish to connect via USB as you would normally with the keyboard, monitor, and mouse connected directly to the computer. After the operating system finishes loading, connect the Switch to the USB computer using the USB A-to-B cable that is part of your USB KVM cable. Your computer should recognize your Switch and automatically install the HID USB driver if it has not already been installed on your USB computer. Once your computer

finishes installing the USB driver, you can power down your computer and prepare to connect it to

the Switch.

1. Using an OmniView KVM Cable (F3X1962-XX or F3X1895-XX-GLD), plug in the male VGA

connector to the VGA port on the computer. Connect the other end (the female connector)

of the VGA cable to the back of the Switch for the appropriate port you wish to connect to (for example, “VGA 02”).

2.Connect the USB cable’s A-type connector to an available USB port on your USB computer. Connect the other end of the USB cable (with the B-type connector) to the corresponding port on the back of the Switch (for example, “USB 02”).

Note: We recommend you attach the KVM cable directly to a free USB port on your computer.

Repeat steps 1 and 2 above for each additional USB computer you wish to connect.