4
4.The program will begin installing at this point. The first screen you will see is the following:
•Select “F1U109” because that is the autoswitch that you have.
•Select which LPT port you installing the AutoSwitch on. Normally, it is always LPT1.
• Click continue when done.
5.The install program will then ask you for the location of the install files. Because your floppy drive is “A:”, just click OK.
6.When done, the program will display the following message:
Click OK, and installation is complete!
7.Next, you will see a box with the following
instructions. Click OK.
8.Reboot your computer. THIS IS A VERY IMPORTANT STEP!!! YOU MUST REBOOT, OTHERWISE, THE SOFTWARE WILL NOT INITIALIZE, AND YOU CANNOT CONTINUE PROPERLY. Do this by clicking on START, SHUT DOWN, and RESTART.