Belkin P74080 user manual Assembling Your Drive Enclosure

Page 7

P74080-F5U209-man_8-02.qxd 8/26/02 12:36 PM Page 3

ASSEMBLING YOUR DRIVE ENCLOSURE

1.Remove top of the External Drive.

2.If you are installing a 31/2-inch hard drive, check to make sure your drive is set to “Master” (see jumper setting information printed on top of your disk drive), then connect the 34-position data cable and 4-position power cable.

3.If you are installing a CD/CD-RW drive, check to make sure your drive is set to “Master”, then connect the

34-position data cable, 4-position power cable, and 4-position audio cable.

4.Choose the set of mounting holes that match the drive you intend to use, and install at least four of the provided mounting screws.

3

Image 7
Contents P74080 Hi-Speed USB External Drive EnclosureP74080-F5U209-man8-02.qxd 8/26/02 1236 PM Page b Table of Contents P74080-F5U209-man8-02.qxd 8/26/02 1236 PM Page d Introduction Hardware Operating System System RequirementsAssembling Your Drive Enclosure Assembling Your Drive Enclosure Assembling Your Drive Enclosure Assembling Your Drive Enclosure Assembling Your Drive Enclosure Windows 98 SE Driver InstallationWindows Me/2000/XP Windows Safe Removal of the USB Disk from WindowsFormat under Windows 98/Me Format the USB 2.0 External DriveControl Panel Method Format the USB 2.0 External Drive Format the USB 2.0 External Drive Partition under Windows 2000/XP Format the USB 2.0 External Drive CE Declaration of Conformity InformationBelkin Corporation