TRENDnet BRM504 manual Physical Details, Front-mounted LEDs, Rear Panel

Introduction

Physical Details

Front-mounted LEDs

Broadband ADSL Router User Guide

Rear Panel

Power LED (Green)

Status LED (Yellow)

Figure 2: Front Panel

On - Power on.

Off - No power.

Off - Normal operation.

Blinking - This LED blinks during start up, and during a Firmware Up- grade.

	Figure 3: Rear Panel
ADSL port	Connect this port to your ADSL line.
10/100BaseT	Use standard LAN cables (RJ45 connectors) to connect your PCs to
LAN connections	these ports.
	Note:
	Any LAN port on the Broadband ADSL Router will automatically
	function as an "Uplink" port when required. Just connect any port to
	a normal port on the other hub, using a standard LAN cable.
Reset Button	This button will reset the Broadband ADSL Router to the factory
(Reset to Defaults)	default settings.

LAN	For each port, there are 2 LEDs, to indicate the connection speed
	(10BaseT or 100BaseT) of each port.
	• 100BT - This will be ON if the LAN connection is using 100BaseT,
	and Blinking if data is being transferred via the corresponding LAN
	port.
	• 10BT - This will be ON if the LAN connection is using 10BaseT, and
	Blinking if data is being transferred via the corresponding LAN port.
	• If neither LED is on, there is no active connection on the correspond-
	ing LAN port.
ADSL	On - ADSL connection established.
	Off - No ADSL connection currently exists.
	Flashing - ADSL is synchronizing.
Internet	On - Internet connection is available.
	Off - No Internet connection available.
	Flashing - Data is being transmitted or received via the ADSL connection.

	To do this, press and hold the Reset Button for five (5) seconds, until
	the Status LED is lit, then release the Reset Button, and wait the
	Broadband ADSL Router to restart using the factory default values.
Power port	Connect the supplied power adapter here.

5 6