TRENDnet TEW-P1PG Hardware Installation, Networking Application, Installing the Print Server

2

HARDWARE

INSTALLATION

Networking Application

The following diagram explains the application of your print server.

- 11 -

Installing the Print Server

Follow these steps for a trouble-free start of operations with your print server.

1.Confirm proper operation of the printer to be connected to the print server.

2.When you have confirmed proper operation of the printer, turn off the power.

3.Confirm that your network is operating normally.

4.Connect the print server to the network (through the RJ-45 connector of the print server).

5.While the printer is powered off, connect the print server to the printer’s Parallel port.

6.Turn on the printer’s power.

7.Connect the DC end of the AC Power adapter to the DC power input socket of the print server and the AC end to the wall outlet. This will supply power to the print server immediately.

NOTE:This print server is built with a default IP Address. To prevent from any conflict in your network, it is recommended to use the PS-Utility program to change the IP setting when there is some other device’s IP Address is the same as the print server’s default IP Address.

- 12 -