Star Micronics IS-NP192 user manual Connecting a serial cable

Page 6

And secure interface unit in place with the two small screws. Finally, install the printer cover.

Connecting a serial cable

• Unplug the printer from its AC power outlet.

Plug one end of a serial cable into the printer’s serial port and secure it in place with the two screws on the cable.

Plug the other end of the serial cable into one of your computer’s serial ports. Serial ports are usually marked COM1, COM 2, etc. If your com- puter has only one serial port, it will be marked COM1.

4

Image 6
Contents Serial Interface Unit Модуль Последовательного Интерфейса Пðåäóïðåæäåíèå English Installation Serial Interface UnitUnpacking Installing the serial interface unit Connecting a serial cable Setting the printer’s Electronic DIP switches EDS EDS-2 SettingsSwitch 1 Data Length Switch 4 Protocol Switch 2 Parity CheckSwitch 3 Parity Switches 5, 6 Not usedSwitches 4, 5, 6 Not used Software Settings Setting up a serial connection on an MS-DOS computerTechnical Specifications Input Connector Signals and FunctionsРóññêèé Мîäóëü ïîñëåäîâàòåëüíîãî èíòåðôåéñà РàñïàêîâêàИíñòàëëяöèя Иíñòàëëяöèя ìîäóëя ïîñëåäîâàòåëüíîãî èíòåðôåéñà Пîäñîåäèíåíèå ïîñëåäîâàòåëüíîãî êàáåëя Уñòàíîâêà ýëåêòðîííûõ ДИП-ïåðåêëþ÷àòåëåé ïðèíòåðà EDS Вûñòàâêè ðåæèìà EDS-2Пåðåêëþ÷àòåëü 1 Дëèíà äàííûõ Пåðåêëþ÷àòåëü 4 Пðîòîêîë Пåðåêëþ÷àòåëü 2 Пðîâåðêà ÷åòíîñòèПåðåêëþ÷àòåëü 3 Чåòíîñòü Пåðåêëþ÷àòåëè 5,6 Нå èñïîëüçóþòñяУñòàíîâêà ïîñëåäîâàòåëüíîãî ñîåäèíåíèя íà MS-DOS êîìïüþòåðå Тåõíè÷åñêèå óñëîâèя Вõîä Сèãíàëû è ôóíêöèè ñîåäèíèòåëяPage KEI International Corporation