Star Micronics SF-15HA user manual Preparing the printer, Installing the automatic sheet feeder

Page 6

2SF-15HA Automatic Sheet Feeder

Preparing the printer

❏Enter the printer’s EDS Mode and make the setting that tells the printer that the ASF is installed (with LC-1511/1521/4511/4521 models, Bank A, Switch 4 is OFF). Refer to the User’s Manual that comes with the printer for details on using the EDS Mode.

❏Unplug the printer from its AC power source.

❏Open the mute cover of the printer.

❏Push the release lever back to the cut-sheet position.

❏Open the rear cover by pushing it back so the cover swings back and down.

Rear cover

Release lever

Mute cover

❏Break away the two small pieces from the rear cover as shown in the illustration above.

You can do this by using a pair of electrician’s pliers or similar tool to clip the four plastic tabs that hold each of the pieces in place.

If you do not have any tools available, repeatedly press down where indicated by the arrows a number of times until the tabs weaken and the pieces break free.

❏Close the rear cover.

Installing the automatic sheet feeder

❏If you have not already done so:

✓Make sure that the printer is unplugged from its AC power source.

✓Open the mute cover and rear cover of the printer.

✓Push the release lever back to the cut-sheet position.

✓Remove the small pieces from the rear cover.

✓Close the rear cover.

See the procedure under “Preparing the printer” in the previous section for details.

Image 6

Contents SF-15HA Page Anmerkungen Table of Contents SF-15HA Automatic Sheet Feeder UnpackingInstalling the automatic sheet feeder Preparing the printerSF-15HA Automatic Sheet Feeder Installing the automatic sheet feeder Loading paper Loading paper Feeding a single sheet of paper Operational Precautions CleaningOperational Precautions Troubleshooting Problem Possible CauseSpecifications SpeciﬁcationsAuspacken HinweisWichtig Vorbereitung des Druckers Einbau des automatischen EinzelbatteinzugsVorbereitung des Druckers Automatischer Einzelbatteinzug SF-15HA Papier einlegen Papier einlegenPapierführung Haltclip Einziehen eines Einzelblatts Einziehen eines EinzelblattsVorsichtsmaßregeln zum Betrieb ReinigungFehlersuche FehlersucheTechnische Daten Déballer le SF-15HA RemarqueInstaller l’introducteur automatique de feuilles Préparer l’imprimanteIntroducteur automatique de feuilles SF-15HA Installer l’introducteur automatique de feuilles Charger du papier Charger du papier Introduire une seule feuille de papier Précautions relatives à l’utilisation Nettoyer l’introducteur automatique de feuillesPrécautions relatives à l’utilisation Guide de dépannage Problème Cause possible Marche à suivreSpéciﬁcations SpécificationsDisimballaggio NotaImportante Installazione del caricatore automatico fogli singoli Preparazione della stampantePreparazione della stampante Caricatore automatico fogli singoli SF-15HA Caricamento della carta Caricamento della cartaGuide carta Linguetta di arresto Inserimento di un singolo foglio di carta Inserimento di un singolo foglio di cartaPrecauzioni d’uso PuliziaRicerca e soluzione dei problemi Ricerca e soluzione dei problemiSpeciﬁche tecniche Customer service information Serviceleistungen in Deutschland