Star Micronics NP-IO manual Pica ESC P Elite Escm

I

28

90 LPRINT CHR$(27);"T";

100 LPRINT "on one line."

Here line 30 turns on superscripts with (ESC) “S” 0. It’s turned off in line 50 with (ESC) “T”. Then between printing text, subscripts are turned on in line 70 with (ESC) “S” 1, and finally off in line 90. Again, everything prints on one line because of the semicolons.

CHANGING THE PRINT PITCH

In “printer talk,” the number of characters that can be printed in one inch is called the print pitch or character pitch. Normally, your printer is set for 10 characters per inch, which is called pica (and is the same as the pica pitch on most typewriters). This works out to 80 characters per line.

You can also print 12 character per inch (elite pitch). This gives you 96 characters per line.

You can set these pitches by software as shown in the table below.

	Table	3-5
	Print pitch	commands
Pitch	Characters/inch		Control code
Pica	10		(ESC) “P"
Elite	12		(ESC)“M"

Try this program to see how these two pitches work. Be sure to set the printer to draft mode.

10 ' Demo of pica and elite pitches

20 LPRINT CHR$(27);"M";

30 LPRINT "This line is ELITE pitch."

40 LPRINT CHR$(27);"P";

50 LPRINT "This line is PICA pitch (normal)."