TRENDnet TEW-410APB, Wireless 802.11g AP user manual Turn on Power Supply

Page 7

4 Web Management Settings

TURN ON POWER SUPPLY

Quick power cycle can caused system corruption. When power on, be careful not to shut down in about 5 seconds, because data is writing to the flash.

START UP & LOGIN

In order to configure the Wireless 11g AP, you must use your web browser and manually input http://192.168.1.250 into the Address box and press Enter. The Main Page will appear.

To start configure the Wireless 11g AP, you must login as “admin” in the User Name box. And input password “admin” on the password section.

Once you have logged-in as administrator, it is a good idea to change the administrator password to ensure a secure protection to the Wireless 11g AP. The Security Settings section described later in this manual describes how to change the password.

Once you have input the correct password and logged-in, the screen will change to the Setup page screen.

User’s Guide

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents TEW-410APB Copyright Statement Troubleshooting Introduction Safety Notification LED Status Turn on Power Supply Make Correct Network Settings of Your Computer Primary SetupWireless Settings Key WPA-Preshared keyAlgorithms WPA SharedPlease choose your algorithms method. You can select Please input the Authentication port of your Radius serverServer Port Default port being used is Radius server will accept the authentication if bothSystem Operating Mode User’s Guide Status Traffic Log Access Control Authentication Type Advanced WirelessUser’s Guide Description SNMPv2cIdentification Contact Unit NameTo upgrade the AP’s firmware Upgrade FirmwareUser’s Guide Can’t connect to other computers on my LAN LAN Connection Problems I can’t access my APTechnical Support
Top Page Image Contents