TEW-711BR
TRENDnet User’s Guide
∙Add – Saves the static route.
To modify an existing reservation, click on the entry in the static route list. When selected, the entry will be highlighted.
∙Update – Saves changes to an existing static route.
∙Delete – Removes an existing static route.
∙Cancel – Discards changes to existing static route.
How to enable dynamic routing on your router
Routing > Dynamic
You may want set up your router to route computers or devices on your network to other local networks through other routers. If other routers support dynamic routing such as RIP (Routing Information Protocol), you can enable this feature on your router to automatically learn the required routes to reach those networks. It is required that the same dynamic routing protocol and version is also enabled on the other routers in order your router and the other routers to exchange information about the network.
Note: Configuring this feature assumes that you have some general networking knowledge.
Advanced Router Setup
1. Log into your router management page (see “How to access your router management page” on page 11).
2.Click on Routing, and click on Dynamic.
3.Select the appropriate dynamic routing protocol and version communicate with other routers.
∙Transmit – Allows your router to send out network information to other routers so other routers can dynamically build routes to
your network.
o Disabled – Disable sending routing information from your
router to other routers.
o RIP 1 - Sends out routing information to other routers
using the RIP version 1 protocol.
o RIP 2 – Sends out routing information to other routers using the RIP version 2 protocol.
∙Receive - Allows your router to receive network information from
other router so your router can build routes to other networks. o Disabled – Disable receiving routing information from
other routers to your router.
o RIP 1 - Receive routing information from other routers
using the RIP version 1 protocol.
o RIP 2 – Receive routing information from other routers using the RIP version 2 protocol.
4.Click Apply to save the changes or click Cancel to discard the changes.
© Copyright 2011 TRENDnet. All Rights Reserved. | 23 |