TRENDnet User’s Guide |
5.The wireless utility will automatically attempt to authenticate to your wireless network.
6. If the WPS configuration was successful, the following window will appear.
7.If the WPS configuration was failed, the follow window will show on. Try to repeat the steps again if this screen appears.
Push Button Configuration (PBC)
There are 2 ways to run WPS Push Button Configuration. Follow the steps below when using the WPS configuration with the Push Button Configuration (PBC) method through the wireless utility. Please note that WPS will attempt to authenticate in 120 seconds. Make sure you allow this time frame to prevent any failures.
1.Click on the Push Button Configuration (PBC) button, the PIN is shown on the button of the windows.
2.Push the WPS button on your wireless access point or router.
3. If the WPS configuration was successful, the follow window will show on.
© Copyright 2013 TRENDnet. All Rights Reserved.
9