TRENDnet TEW455APBO manual  WPA General Settings

Page 33

User Manual

TEW-455APBO High Power Wireless Outdoor PoE Access Point

Cipher Suite: By default, it is TKIP. Select either AES or TKIP cipher suites

Group Key Update Period: By default, it is 600 seconds. This time interval for rekeying GTK, broadcast/multicast encryption keys, can be specified in the range of 0-99999999seconds. Entering the time-length is required.

Master Key Update Period: By default, it is 83400 seconds. This time interval for rekeying GMK, master key to generate GTKs, can be specified in the range of 0-99999999seconds.

Entering the time-length required.

Key Type: Select either ASCII or HEX format for the Pre-shared Key.

Pre-shared Key: Enter the pre-shared key; the format shall go with the selected key type.

Display: By default, password privacy/masking is enabled. Check this box to disable password privacy and display the characters when entering in a key or password.

Pre-shared key can be entered with either a 256-bit secret in 64 HEX digits format, or 8 to 63 ASCII characters.

WPA-Enterprise/WPA2-Enterprise:The RADIUS authentication and encryption will apply if either one is selected.

WPA General Settings :

Cipher Suite: By default, it is TKIP. Select either AES or TKIP cipher suites

Group Key Update Period: By default, it’s 600 seconds. This time interval for rekeying GTK, broadcast/multicast encryption keys, can be specified in the range of 0-99999999seconds. Entering the time-length is required.

Master Key Update Period: By default, it’s 83400 seconds. This time interval for rekeying GMK, master key to generate GTKs, can be specified in the range of 0-99999999seconds. Enter the time-length required.

EAP Reauth Period: By default, it’s 3600 seconds; 0 second is to disable EAP Re-

30

Image 33
Contents Page Table of Contents Page Introduction of TEW-455APBO System OverviewSystem Concept  Configuration in AP Mode including Access Point + WDS Applications in Wireless Network Configuration in WDS Mode Pure WDS TEW-455APBO High Power Wireless Outdoor PoE Access Point  Configuration in CPE Mode Product Benefit Specification  Authentication/ Encryption Wireless Security  Wireless Feature System Administration  Quality of ServiceWireless Performance Considerations Hardware Installation Basic InstallationPackage Contents Panel Function DescriptionsWeb Management Interface Instructions  Launch Web Browser  System Login Login Success Option System Wireless Administrator Status AP Mode ConfigurationExternal Network Connection Network RequirementConfigure LAN IP  802.1d Spanning Tree Wireless LAN Network Creation Wireless General SetupVAP Setting, Security Settings, and Access Control Settings Output Power Chart FCC Domain Etsi Domain Level Wireless Advanced Setup RTS/CTS TEW-455APBO High Power Wireless Outdoor PoE Access Point TEW-455APBO High Power Wireless Outdoor PoE Access Point Virtual AP Overview Create Virtual AP VAPTEW-455APBO High Power Wireless Outdoor PoE Access Point Virtual AP Setup TOS Ascii Key Length Hex WPA General Settings  Main or Secondary Accounting Radius Server Settings  Main and secondary Authentication Radius Server Settings Dynamic WEP Settings  Main and secondary Accounting Radius Server Settings MAC Filter Setup  Only Allow List MAC Only Deny List MAC 3shows Point to Multiple Points with different Vlan settings Wireless Network ExpansionTOS  WDS MAC List Configure Management System Management System Information Privileges TEW-455APBO High Power Wireless Outdoor PoE Access Point Configure System Time Configure UPnP Configure Snmp Setup TEW-455APBO High Power Wireless Outdoor PoE Access Point Backup / Restore and Reset to Factory Upgrade Firmware UpgradeNetwork Utility Reboot System Overview System StatusTEW-455APBO High Power Wireless Outdoor PoE Access Point  Status On/Off Associated Clients Status Status On/Off WDS Link StatusExtra Information TEW-455APBO High Power Wireless Outdoor PoE Access Point Event Log 1Point to Point Configuration WDS Mode Configuration2shows Point to Multiple Points with different Vlan settings WDS Setup WDS MAC List System Status TEW-455APBO High Power Wireless Outdoor PoE Access Point WDS Link Status System Wireless Advance Utilities Status CPE Mode ConfigurationConfigure WAN Setup  Reconnect Mode DNS Configure Ddns Setup Site Survey IP Filter Setup Access Control ListRule Source Destination SideIP/Mask Port Two ways to set the Access Control List 1 DMZ Resource SharingVirtual Server Port Forwarding TCP System Status TEW-455APBO High Power Wireless Outdoor PoE Access Point TEW-455APBO High Power Wireless Outdoor PoE Access Point TEW-455APBO High Power Wireless Outdoor PoE Access Point Dhcp Clients Accessing the CLI with Telnet Command Line InterfaceCLIAccessing the CLI with SSH Utility Using the CLI  Wireless Type W to open Choose Device window  Specify Packet Size Enter packet size  Using password command Change root password Table a WEB GUI Valid Characters Appendix A. WEB GUI Valid CharactersSnmp Block Field Valid Characters General Setup DMZ Appendix B. Network manager Privileges Main Menu Sub Menu Group Admin PrivilegeAppendix C. Enabling UPnP in Windows XP TEW-455APBO High Power Wireless Outdoor PoE Access Point Limited Warranty PWP05202009v2 TEW-455APBO High Power Wireless Outdoor PoE Access Point