TRENDnet TEW455APBO manual Access Control List, IP Filter Setup

Page 71

User Manual

TEW-455APBO High Power Wireless Outdoor PoE Access Point

5.2 Access Control List

5.2.1 IP Filter Setup

Allows to create deny or allow rules to filter ingress or egress packets from specific source and/or to destination IP address on wired (LAN) or Wireless (WAN) ports. Filter rules could be used to filter unicast or multicast packets on different protocols as shown in the IP Filter Setup. Important to note that IP filter rules has precedence over Virtual server rules.

Please click on Advance -> IP Filter Setup and follow the below setting.

Source Address/Mask : Enter desired source IP address and netmask; i.e. 192.168.2.10/32.

Source Port : Enter a port or a range of ports as start:end; i.e. port 20:80

Destination Address/Mask : Enter desired destination IP address and netmask; i.e. 192.168.1.10/32

Destination Port : Enter a port or a range of ports as start:end; i.e. port 20:80

In/Out : Applies to Ingress or egress packets

Protocol : Supports TCP, UDP or ICMP.

Listen : Click Yes radial button to match TCP packets only with the SYN flag.

68

Image 71
Contents Page Table of Contents Page Introduction of TEW-455APBO System OverviewSystem Concept  Configuration in AP Mode including Access Point + WDS Applications in Wireless Network Configuration in WDS Mode Pure WDS TEW-455APBO High Power Wireless Outdoor PoE Access Point  Configuration in CPE Mode Product Benefit Specification  Authentication/ Encryption Wireless Security  Wireless Feature System Administration  Quality of ServiceWireless Performance Considerations Panel Function Descriptions Basic InstallationHardware Installation Package ContentsWeb Management Interface Instructions  Launch Web Browser  System Login Login Success Network Requirement AP Mode ConfigurationOption System Wireless Administrator Status External Network ConnectionConfigure LAN IP  802.1d Spanning Tree VAP Setting, Security Settings, and Access Control Settings Wireless LAN Network CreationWireless General Setup Output Power Chart FCC Domain Etsi Domain Level Wireless Advanced Setup RTS/CTS TEW-455APBO High Power Wireless Outdoor PoE Access Point TEW-455APBO High Power Wireless Outdoor PoE Access Point Virtual AP Overview Create Virtual AP VAPTEW-455APBO High Power Wireless Outdoor PoE Access Point Virtual AP Setup TOS Ascii Key Length Hex WPA General Settings  Main or Secondary Accounting Radius Server Settings  Main and secondary Authentication Radius Server Settings Dynamic WEP Settings  Main and secondary Accounting Radius Server Settings  Only Deny List MAC MAC Filter Setup Only Allow List MAC 3shows Point to Multiple Points with different Vlan settings Wireless Network ExpansionTOS  WDS MAC List  System Information Configure ManagementSystem Management Privileges TEW-455APBO High Power Wireless Outdoor PoE Access Point Configure System Time Configure UPnP Configure Snmp Setup TEW-455APBO High Power Wireless Outdoor PoE Access Point Backup / Restore and Reset to Factory Upgrade Firmware UpgradeNetwork Utility Reboot System Overview System StatusTEW-455APBO High Power Wireless Outdoor PoE Access Point  Status On/Off Associated Clients Status Status On/Off WDS Link StatusExtra Information TEW-455APBO High Power Wireless Outdoor PoE Access Point Event Log 1Point to Point Configuration WDS Mode Configuration2shows Point to Multiple Points with different Vlan settings WDS Setup WDS MAC List System Status TEW-455APBO High Power Wireless Outdoor PoE Access Point WDS Link Status System Wireless Advance Utilities Status CPE Mode ConfigurationConfigure WAN Setup  Reconnect Mode DNS Configure Ddns Setup Site Survey IP Filter Setup Access Control ListIP/Mask Port Rule Source DestinationSide Two ways to set the Access Control List 1 DMZ Resource SharingVirtual Server Port Forwarding TCP System Status TEW-455APBO High Power Wireless Outdoor PoE Access Point TEW-455APBO High Power Wireless Outdoor PoE Access Point TEW-455APBO High Power Wireless Outdoor PoE Access Point Dhcp Clients Accessing the CLI with Telnet Command Line InterfaceCLIAccessing the CLI with SSH Utility Using the CLI  Wireless Type W to open Choose Device window  Specify Packet Size Enter packet size  Using password command Change root password Table a WEB GUI Valid Characters Appendix A. WEB GUI Valid CharactersSnmp Block Field Valid Characters General Setup DMZ Appendix B. Network manager Privileges Main Menu Sub Menu Group Admin PrivilegeAppendix C. Enabling UPnP in Windows XP TEW-455APBO High Power Wireless Outdoor PoE Access Point Limited Warranty PWP05202009v2 TEW-455APBO High Power Wireless Outdoor PoE Access Point