TRENDnet TEW623PI manual Software Installation, Windows Utility and Driver Installation

Page 11

SOFTWARE INSTALLATION

This section describes how to install the driver and utility for the 300Mbps Wireless N PCI Adapter.

Note: DO NOT install the 300Mbps 802.11g Wireless LAN Adapter in the computer until instructed to do so.

Windows Utility and Driver Installation

1) Insert the CD-ROM into your CD-ROM drive, the Autorun will appear.

2)Click “Install Utility & Driver” icon to install the driver and software and the install wizard will begin installing the software. Follow the install wizard instructions to complete the installation.

3)Follow the Install Shield Wizard Instructions. Click “Next” to continue and finish it.

4)Once the utility is installed, turn off the PC, open the cover and install the TEW-623PI adapter to the available PCI slot. Attach the antennas, close the cover and boot up the PC again. The windows will detect new hardware and install the appropriate driver automatically.

4

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page Federal Communication Commission Interference Statement Regulatory Information/disclaimersFCC Radiation Exposure Statement Important NoteEN 300 328 V1.6.1 Europe EU Declaration of ConformityEN 60 950-1 2001 +A11 EN 50392Export restrictions CE Mark Warning Safety InformationProtection requirements for health and safety Article 3.1a CE in which Countries where the product may be used freelyTable of Content Overview of this User’s Guide IntroductionUnpacking SetupLink LED Indicator for CardBusLED Indicator for PCI Check the installationWindows Utility and Driver Installation Software InstallationWindows Wireless Utility Setting Link Information Configuration Open or Shared Key WPA-PSK/WPA2-PSK Site Survey Profile WPS Push the button on my access pointPage Enter a PIN into my access point Page About General Technical SpecificationsPhysical and Environmental Limited Warranty PWP05202009v2
Top Page Image Contents