TRENDnet TEW623PI manual Enter a PIN into my access point

Page 21

Enter a PIN into my access point

Using the WPS configuration with the “Enter a PIN into my access point” method, the configuration steps as below:

1)Selected the “Enter a PIN into my access point”, the PIN will be show on the button of the windows.

2)Enter the PIN code into the WPS “Clint PIN number” of you wireless access point or router then click the Start PIN button, the wireless access point or router will start the WPS configuration process.

3)Selected a wireless access point or router which one will be connecting then click the Next button start the WPS configuration. If the “Automatically select the network” was checked, the setup step will be skip.

Image 21
Contents Page Federal Communication Commission Interference Statement Regulatory Information/disclaimersFCC Radiation Exposure Statement Important NoteEN 60 950-1 2001 +A11 Europe EU Declaration of ConformityEN 50392 EN 300 328 V1.6.1Export restrictions Protection requirements for health and safety Article 3.1a Safety InformationCE in which Countries where the product may be used freely CE Mark WarningTable of Content Overview of this User’s Guide IntroductionUnpacking SetupLED Indicator for PCI LED Indicator for CardBusCheck the installation LinkWindows Utility and Driver Installation Software InstallationWindows Wireless Utility Setting Link Information Configuration Open or Shared Key WPA-PSK/WPA2-PSK Site Survey Profile WPS Push the button on my access pointPage Enter a PIN into my access point Page About General Technical SpecificationsPhysical and Environmental Limited Warranty PWP05202009v2