TRENDnet TEW623PI manual Wps, Push the button on my access point

Page 19

WPS

Wi-Fi Protected Setup (WPS) is an optional certification program from the Wi-Fi Alliance that is designed to ease the task of setting up and configuring security on a wireless network. There are two methods used in the WPS as below instruction.

Push the button on my access point

Using the WPS configuration with the “Push the button on my access point” method, the configuration steps as below:

1) Selected the “Push the button on my access point”.

2)Push the WPS configuration button on your wireless access point or router.

3)Click the Next button start the WPS configuration.

12

Image 19

Contents Page Federal Communication Commission Interference Statement Regulatory Information/disclaimersFCC Radiation Exposure Statement Important NoteEN 300 328 V1.6.1 Europe EU Declaration of ConformityEN 60 950-1 2001 +A11 EN 50392Export restrictions CE Mark Warning Safety InformationProtection requirements for health and safety Article 3.1a CE in which Countries where the product may be used freelyTable of Content Overview of this User’s Guide IntroductionUnpacking SetupLink LED Indicator for CardBusLED Indicator for PCI Check the installationWindows Utility and Driver Installation Software InstallationWindows Wireless Utility Setting Link Information Configuration Open or Shared Key WPA-PSK/WPA2-PSK Site Survey Profile WPS Push the button on my access pointPage Enter a PIN into my access point Page About General Technical SpecificationsPhysical and Environmental Limited Warranty PWP05202009v2