Transition Networks SCSCF30XX-10X specifications SCSCF30xx-10x

User’s Guide

SCSCF30xx-10x

Stand-Alone Device

•DS3 or T3 / E3

•Coax (BNC) to Fiber

Transition Networks SCSCF30xx-10x series Devices encode and decode DS3 or E3 coax copper signals over fiber optic cable to extend the distance and transmission reliability of high- speed DS3 or E3 data traffic. The SCSCF30xx- 10x also connects remote locations via T3/E3 cable.

Part Number	Port One - Copper	Port Two - Duplex Fiber-Optic
SCSCF3011-100	75 ohm coax (BNC)	ST, 1300 nm multimode
		2 km (1.2 miles)*
SCSCF3013-100	75 ohm coax (BNC)	SC, 1300 nm multimode
		2 km (1.2 miles)*
SCSCF3014-100	75 ohm coax (BNC)	SC, 1310 nm singlemode
		20 km (12.4 miles)*
SCSCF3015-100	75 ohm coax (BNC)	SC, 1310 nm singlemode
		40 km (24.8 miles)*
SCSCF3016-100	75 ohm coax (BNC)	SC, 1310 nm singlemode
		60 km (37.3 miles)*
SCSCF3017-100	75 ohm coax (BNC)	SC, 1550 nm singlemode
		80 km (49.7 miles)*
SCSCF3018-100	75 ohm coax (BNC)	MT-RJ, 1300 nm multimode
		2 km (1.2 miles)*
SCSCF3019-100	75 ohm coax (BNC)	LC, 1310 nm single mode
		20 km (12.4 miles)*
SCSCF3029-100	75 ohm coax (BNC)	SC, 1310 mn (TX)/1550 nm (RX)
		20 km (12.4 miles)*
SCSCF3029-101	75 ohm coax (BNC)	SC, 1550 mn (TX)/1310 nm (RX)
		20 km (12.4 miles)*

SCSCF3029-100and -101are intended to be installed in the same network where one is the local converter and the other is the remote converter.

*Typical maximum cable distance. Actual distance is dependent upon the physical characteristics of the network.

Note: The CCSCF30xx-10x model is the chassis version of the Device. For more information, see the CCSCF30xx-10x user’s guide on-line at www.transition.com.

Installation	. .2
Operation	. .6
Cable Specifications	. .7
Technical Specifications	. .8
Troubleshooting	. .9
Compliance Information	.12