Transition Networks CSRFB10XX-100 Operation, Install the twisted-pair copper cable, Status LEDs

CSRFB10xx-100

Installation -- Continued

Install the twisted-pair copper cable

1.Locate IEEE 803.2 compliant 10Base-T or 100Base-TX cable with RJ-45 connectors installed on both ends.

2.Connect the RJ-45 connector at one end of the cable to the RJ-45 port connector on the media converter.

3.Connect the RJ-45 connector at the other end of the cable to the RJ-45 port connector on the other converter (switch, workstation, etc.).

Note: The MDI (straight-through)or MDI-X (crossover) cable connection is configured automatically, when the AutoCross jumper is in the enabled position.

Point System Chassis

RJ-45 Port
	RJ-45 Port
Media Converter
	On other device
	(workstation, switch, etc.)

Install the fiber cable

1. Locate or build IEEE 803.2™ compliant 100Base-FX fiber cable with male,

two-stranded TX to RX connectors installed at both ends.

Operation
Status LEDs
	LED	Description
	Power	ON = Power
		OFF = No power		DPX LACT PWR
	Fiber LEDs
	Link/Activity	Green ON Solid = Link, OFF = no link	TX
		Green Blink = Activity	100Base-FX
	Duplex (FD)	Green ON = Full Duplex
		OFF = Half Duplex
	Copper LEDs
	Link/Activity	Green ON Solid = Link, Blink = Activity	RX
	(LED2)	Blink = Rx Data
	Duplex (LED2)	Green ON = Full Duplex, Blink = Activity
		Yellow ON = Half Duplex, Blink = Activity	10/100Base-
					LED 2
	Speed (LED1)	Green=100 Mbps
		Yellow =10 Mbps
			TX		LED 1
				Link Test
				CSRFB

Product Features

2.	Connect the fiber cables to the CSRFB10xx-100 media converter as described:
	•	Connect the male TX cable connector to the female TX connector.
	•	Connect the male RX cable connector to the female RX connector.
3.	Connect the fiber cables to the other converter (media converter, hub, etc.) as
	described:
	•	Connect the male TX cable connector to the female RX connector.
	•	Connect the male RX cable connector to the female TX connector.

Connect fiber cable	Connect fiber cable
to media converter	to other device
as shown.	(media converter,
	hub, etc.) as shown

Link Test button

Press the Link Test button to bypass TLPT when enabled.

Note: This is a momentary override button; when released, the connection will return to its previous state.

AutoCross™

10/100Base-TX

LinkTest CSRFB

Link Test

Button

RX	RX
TX	TX

The AutoCross feature detects and configures the twisted-pair copper port on the CSRFB10xx-100 media converter to the correct straight-through (MDI) or crossover (MDI-X) configuration. This feature allows either MDI or MDI-X cable to connect the media converter to converters such as hubs, transceivers, or network interface cards (NICs). (This feature does not require operator intervention.)

6 24-hour Technical Support: 1-200-260-1312 -- International: 00-1-952-941-7600 techsupport@transition.com -- Click the “Transition Now” link for a live Web chat. 7