User’s Guide
S4TEF10xx-11x
Stand-Alone Media Converter
• Twisted-Pair Copper to Fiber
• 10/100Base-TX to 100Base-FX
• RS-232 to Fiber
• (4) T1/E1 to Fiber
The S4TEF10xx-11x media converter is designed to extend signals from a 10Base-T Ethernet/100Base-TX Fast Ethernet port, an RS-232 data port, and up to four (4) T1/E1
network ports over fiber. The Ethernet, RS-232, and T1/E1 interfaces are independent of each other and the signals from these ports can be sent over the fiber interface simultaneously.
The S4TEF10xx-11x is designed to be installed in pairs. For example, install one S4TEF1011-110 as the local media converter and another S4TEF1011-110 as the remote media converter. All S4TEF10xx-11x models have the following copper connectors.
Connector Type | Number | Description |
Ethernet | 1 | RJ-45, 100 Mb/s, 100 m (328 ft.)* |
RS-232 | 1 | 6-pin, DIN serial 3.2 m (10 ft.)* |
T1 | 4 | RJ-48 |
The various fiber connectors are available on separate models. Both duplex and single mode fiber optic converters are available:
| Part Number | Duplex Fiber-Optic - 100Base-FX |
| S4TEF1011-110 | ST, 1300 nm multimode, 2 km (1.2 miles)* |
| S4TEF1013-110 | SC, 1300 nm multimode, 2 km (1.2 miles)* |
| S4TEF1014-110 | SC, 1310 nm single mode, 20 km (12.4 miles)* |
| S4TEF1015-110 | SC, 1310 nm single mode, 40 km (24.8 miles)* |
| S4TEF1016-110 | SC, 1310 nm single mode, 60 km (37.2 miles)* |
| S4TEF1017-110 | SC, 1550 nm single mode, 80 km (49.7 miles)* |
| S4TEF1018-110 | MT-RJ, 1300 nm multimode, 2 km (1.2 miles)* |
| | |
| S4TEF1029-11x | (Single mode, single fiber models are listed on page 2.) |
| | |
*Typical maximum cable distance. Actual distance is dependent upon the physical characteristics of the network.
The chassis version of the media converter is C4TEF10xx-11x. For more information, see the user’s guide on-line at: www.transition.com.
Installation | .2 |
Operation | 10 |
Cable Specifications | 19 |
Technical Specifications | 23 |
Troubleshooting | 24 |
Contact Us | 26 |
Compliance Information | 27 |