Transition Networks SBFTF1010-130 specifications Installation, Jumper shunt, Set DIP Switch

SBFTF1010-130

Installation

CAUTION: Do Not install the SBFTF1010-130 fault-tolerant redundant link protector in location where it might be exposed to wetness. Failure to observe this caution could result in damage to the device.

Jumper (shunt)

The 3-pin header located on the inner surface of the board is used to select “redundancy.” See photo below. Redundancy Mode automatically switches data transfer responsibilities to the seconday port if the primary port fails.

SBFTF1010-130

Installation -- Continued

Note: See the diagrams below and use a very small flatblade screwdriver or similar tool to set the DIP switch.

1 2 3 4		When Auto-Negotiation is enabled (switch #1 UP), the bridging media
	Up	converter advertises all rate and mode capabilities to the network:
		100Mb/s full duplex, 100Mb/s half-duplex, 10Mb/s full duplex, and
		10Mb/s half duplex.

Note: Switches “#3” and “#4” are non-functional when switch “#1” is in the UP position (Auto-Negotiation enabled).

J2 (3-Pin Header)

Letter “R” = Redundant

1 2 3 4

Down

1 2 3 4

Up

When auto-negotiation is disabled (switch #1 DOWN), the bridging media converter does not advertise rate and mode capabilities to the network.

100Base-TX data transfer rate (switch #2 UP), 100 Mbps fast Ethernet.

Shunt in Redundant Position (Default)

Set DIP Switch

4 DIP Switches

1 2 3 4

Down

1	2	3	4
	Up

10Base-TX data transfer rate (switch #2 DOWN), 10 Mbps fast Ethernet.

Full duplex switch #3 UP.

RJ-45 Ports

Side View

Four (4) Dip Switches

•SW 1: Auto-Negotiation

•SW 2: Speed

•SW 3: Duplex

•SW 4: Redundancy

1	2	3	4	Half duplex switch #3 DOWN.
Down
1	2	3	4	Redundancy enabled switch #4 UP. (See note below)
		Up

1 2 3 4 Redundancy disabled switch#4 DOWN.

Down

Note: With redundancy turned OFF, the primary and secondary port LEDs will turn OFF; therefore, returning these ports to normal functionality.

Note: The functionality for each switch setting applies to all ports simultaneously.

4 Tech Support: 1-800-260-1312 International: 00-1-952-941-7600, 24 hours techsupport@transition.com -- Click the “Transition Now” link for live Web chat. 5