IBM 6 MPLS manual Using the LSP Browser

Page 11

Specialized Models User Guide

6 MPLS Model User Guide

LSP Browser

After you create the LSPs in the network, you may want to edit or view the default settings. You do this in the LSP browser, which you can access from the Protocols > MPLS > Browse/Edit LSP Information... menu item. The browser enables you to

•Set the hop type of LERs

•Set the start and end times for the LSP

•Set threshold values for bandwidth, delay, and hop counts in the LSP

•Hide some or all of the LSPs from view in the Project Editor workspace

•Export LSP configuration details to a file

Figure 6-13 Using the LSP Browser

This column indicates if the attribute values shown are from the GUI or the LSP specification file.

These attributes set the LSP’s Path Details and Setup, TE, and Recovery Parameters attributes.

Clicking here toggles the display settings—the workspace is immediately refreshed to show or hide the LSPs.

Clicking OK saves the current settings in the LSP specification file or creates this file if one does not yet exist.

Modeler/Release 10.0

SPM-6-11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents End of Table Model FeaturesMpls Model Features Feature DescriptionReference Documents Model Features DocumentModel Attributes Mpls Configuration Object AttributesNode Models Specifying FEC Attributes Specifying Traffic Trunk Profiles Router Attributes Traffic Mapping ConfigurationConfiguring TE Bindings Simulation Attributes Configuring LDP ParametersLSP Attributes Configuring an LSP’s AttributesSetup Parameters-specifies the duration of the LSP LSP Browser 13 Using the LSP Browser14 Selecting Statistics to Collect Available StatisticsCreating LSPs Configuring Mpls in a NetworkProcedure 6-1 Creating Dynamic LSPs from Demands Procedure 6-2 Creating Dynamic LSPs Manually End of ProcedureProcedure 6-3 Creating Static LSPs Creating FECs and Traffic Trunks Procedure 6-4 Creating FECsProcedure 6-5 Creating a Default Traffic Trunk Creating TE Bindings on LERs Procedure 6-6 Creating a TE BindingProcedure 6-8 Using an LSP Configuration File in a Scenario Procedure 6-7 Exporting LSP Configuration to an Ascii FileApplying QoS to an Mpls Network Model 15 Configuring QoS on an LER Menu Item Description Mpls Menu OperationsMpls Menu Summary Process model Description Information for Opnet Modeler UsersModel Architecture Mpls Process Models
Top Page Image Contents