IBM 6 MPLS manual Setup Parameters-specifies the duration of the LSP

Page 10

Specialized Models User Guide

6 MPLS Model User Guide

Figure 6-10 Recovery Parameters Configuration

•Setup Parameters—specifies the duration of the LSP.

Figure 6-11 Setup Parameters Configuration

•TE Parameters—specifies the traffic engineering constraints used by CR-LDP to find a route through the network. CR-LDP uses Constrained Routing to find the route that is the best fit for the specified constraints. This attribute applies to dynamic LSPs only. Make sure you account for network bandwidth availability when configuring static LSPs.

Figure 6-12 TE Parameters Configuration

SPM-6-10

Modeler/Release 10.0

Image 10

Contents Feature Description Model FeaturesMpls Model Features End of TableModel Features Document Reference DocumentsNode Models Mpls Configuration Object AttributesModel Attributes Specifying FEC Attributes Specifying Traffic Trunk Profiles Traffic Mapping Configuration Router AttributesConfiguring TE Bindings Configuring LDP Parameters Simulation AttributesConfiguring an LSP’s Attributes LSP AttributesSetup Parameters-specifies the duration of the LSP 13 Using the LSP Browser LSP BrowserAvailable Statistics 14 Selecting Statistics to CollectProcedure 6-1 Creating Dynamic LSPs from Demands Configuring Mpls in a NetworkCreating LSPs End of Procedure Procedure 6-2 Creating Dynamic LSPs ManuallyProcedure 6-3 Creating Static LSPs Procedure 6-5 Creating a Default Traffic Trunk Procedure 6-4 Creating FECsCreating FECs and Traffic Trunks Procedure 6-6 Creating a TE Binding Creating TE Bindings on LERsProcedure 6-7 Exporting LSP Configuration to an Ascii File Procedure 6-8 Using an LSP Configuration File in a ScenarioApplying QoS to an Mpls Network Model 15 Configuring QoS on an LER Mpls Menu Summary Mpls Menu OperationsMenu Item Description Mpls Process Models Information for Opnet Modeler UsersModel Architecture Process model Description