Fujitsu TE988G Color Monitor
Trouble Shooting
If you are experiencing difficulties with your monitor, check following table for possible solutions.
Problem |
| Items to check |
? No picture | 1. | The VGA card should be completely seated in the slot. |
| 2. | Power switch of the monitor and the PC should be in the ON |
|
| position. |
| 3. | The signal cable should be completely connected to the video |
|
| card / computer. |
| 4. | Check if the pins of the connector are twisted or shrunk. |
? Image is scrolling or | 1. | The signal cable should be completely connected to the |
unstable |
| computer. |
| 2. | Check the pin assignments and signal timings of the monitor |
|
| and your video card. |
? LED on the monitor is | 1. | Power switch should be in the ON position and the power cord |
not lit |
| should be connected. |
| 2. | Check if the system is in the power saving mode. ( Check by |
|
| pressing any one of keys on the keyboard or moving the |
|
| mouse.) |
? Picture is fuzzy | 1. | Adjust the Contrast and Brightness Controls. |
? Picture bounces or wave | 1.. Move electrical devices that may be causing electrical | |
pattern is present in the |
| interference away from the monitor. |
picture | 2. | Refer to the FCC information of this manual. |
? Edges of the display | 1. | Adjust the geometry control to adjust the display image. |
image are cured either | 2. | Locate the monitor facing to east. |
inward or outward |
|
|
? Display image is not | 1. | Adjust the image using Size and Position Controls in the OSD. |
centered, too small, or |
|
|
too large |
|
|
15