Fujitsu TE988G user manual FCC Information

Page 2

Fujitsu TE988G Color Monitor

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

(1).

Reorient the receiving antenna.

(2).

Increase the separation between the equipment and receiver.

(3).

Connect the equipment into an outlet on a circuit different from that to which

 

the receiver is connected.

(4).

Consult the dealer or an experienced radio TV technician for help.

Notice:

(1)The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

(2)Shielded interference cables must be used in order to comply with the emission

limits.

Energy Declaration

This monitor is equipped with a function for saving of energy which supports the VESA Display Power Management Signaling ( DPMS ) standard. This means that the monitor must be connected to a computer which supports VESA DPMS to fulfill the requirement in the NUTEK specification. Time settings are adjusted from the system unit by software. From indicated inactivity to Power Saving Position A2 the total time must not be set to more than 70 minutes.

NUTEK

VESA State

LED Indicator

Power Consumption

 

 

 

 

Normal operation

ON

Green

120W (Max.)

 

 

 

 

Power Saving Position A1

SUSPEND

Orange

15W (Max.)

 

 

 

 

Power Saving Position A2

OFF

Orange-flash

5W (Max.)

 

 

 

 

We recommend you to switch off the monitor when it is not in use for quite a long time.

1

Image 2
Contents Table of Contents FCC Information Important Safeguards Change without notice Tilt Swivel & Base Connecting the monitor Pin SignalShows the position of following operating units Adjustment Operation Contrast & BrightnessPhase/V-Center Pincushion & Trapezoid function window Phase & V-Center function windowSize & V-size function window Pin Balance & Corner function window Parallelogram & Tilt function windowOSD position function window RGB Color Temperature function windowRGB Value Setting Language function window Tools function windowV60.3 Hz Exit OSD menu function windowCRT Size Trouble Shooting Problem Items to check