Exit Menu Leaving the Setup Utility, Exit Saving

L i f e B o o k S S e r i e s N o t e b o o k B I O S

EXIT MENU – LEAVING THE SETUP UTILITY

The Exit Menu is used to leave the setup utility. Follow the instructions for Navigating Through the Setup Utility to make any changes. (See Navigating Through the Setup Utility on page 2 for more information). The following table shows the names of the menu fields for the Exit menu, the default settings and a description of the field's function and any special information needed to help understand the field's use.

PhoenixBIOS Setup Utility

Main

Advanced

Security

Boot

Exit

Exit Saving Changes

Exit Discarding Changes

Load Setup Defaults

Discard Changes

Save Changes

Item Specific Help

Exit System Setup and save your changes to CMOS.

F1 Help	Select	Item	-/SpaceChange Values
ESC Exit	Select	Menu	Enter	Select ▲ Sub-Menu

Figure 19. Exit Menu

Table 19: Fields, Options and Defaults for the Exit Menu

F9 Setup Defaults

F10 Save and Exit

Menu Field	Description


Exit Saving	Exit Saving Changes and Exit will store all the entries on every menu of the setup utility to the BIOS memory and
Changes	then exit the setup utility. A confirmation message Save Configuration changes and exit now? [Yes]
	[No] will be displayed.

Exit Discarding	Selecting Exit Discarding Changes and Exit will exit the setup utility with out writing to the BIOS memory. When the
Changes	BIOS recognizes this selection it will load the operating system and begin operation.

Load Setup	Selecting Load Setup Defaults will load the factory preset default values for all menu fields, then display the message
Defaults	Load default configuration now? [Yes] [No]. When confirmed the setup utility will return to the Exit
	Menu. To return to another menu follow the directions in the Navigating Through the Setup Utility Section.

Discard Changes	Selecting Discard Changes will load the previous values in BIOS memory for all menu fields. The message Load
	previous now? [Yes] [No] will be displayed. When confirmed the utility will return to the Exit menu. To
	return to another menu, follow the directions in the Navigating Through the Setup Utility Section.

Save Changes	Selecting Save Changes causes the new settings in all menus to be written to the BIOS memory. The message Save
	configuration changes now? [Yes] [No] will be displayed. When confirmed, the setup utility will return
	to the Exit menu. To go to another menu, follow the directions in the Navigating Through the Setup Utility section.