Dragging
Dragging means touching the screen with the stylus, moving and then lifting the stylus. To drag, tap the Touch Screen twice with your stylus over the item you wish to move, making sure to leave your finger on the screen after the final tap. Next, move the item to its new location by moving the stylus across the screen, and then lifting the stylus to release it. Dragging can also be done using your fingertip. (Figure
G e t t i n g t o K n o w Y o u r L i f e B o o k
6.Touch the stylus to various points on the screen to verify that the screen is correctly calibrated. If you are satisfied with the screen’s calibration, press the [ENTER] key. If you are not satisfied, press the [HOME] key to begin again at Step 2.
Figure 2-19 Dragging on the Touch Screen
Calibrating the Touch Screen
In order to ensure accurate tracking between the stylus and cursor, you must run the Touch Screen Calibration Utility before you use the Touch Screen for the first time, or after you change the display resolution.
To run the calibration utility:
1.On the Start menu, point to Programs. Point
to Fujitsu Touch Panel/Compensation Tool. This will
open the Compensation Tool.
2.Adjust the display of your LifeBook to a comfortable angle and find the red + symbol in the
3.Using the stylus, touch the screen near the + symbol and without lifting the tip, move the stylus to the center of the symbol. Once the stylus tip is in the center of the symbol, lift it off the Touch Screen. This will cause the red + to disappear from the corner and reappear in a different place on
your screen.
4.Repeat step 3 until you have selected a total of nine symbols. This is the minimum number of points necessary to calibrate your touch screen.
5.Once you have selected the nine symbols, press the [ENTER] key.
P O I N T
If you receive an error message at this point, you selected fewer than nine symbols. Click OK and begin again at Step 2.
19