Memory Upgrade Module | Fujitsu E-6570 guide

Memory Upgrade

Module

Your LifeBook comes with 64MB or 128MB high speed Synchronous Dynamic RAM (SDRAM) factory installed. To increase your LifeBook’s memory capacity, you may install an additional memory upgrade module. You can also replace the original memory module with a higher capacity module. The memory upgrade must be a dual- in-line (DIMM) SDRAM module, however it can be any capacity up to 512MB (total).

C A U T I O N

Do not remove any screws from the memory upgrade module compartment, except the ones specifically shown in the directions for installing and removing the memory upgrade module.

INSTALLING A MEMORY UPGRADE MODULE

1.Turn off power to your LifeBook using the power switch, and remove any power adapter

(AC or auto/airline).

2.Make sure that all the connector covers are closed.

3.Turn the LifeBook bottom side up, with the front panel toward you.

4.Remove the screw at the front of the memory upgrade module compartment. (Figure 4-10)

5.Remove the cover by tilting the front edge up and then pulling forward until the tabs on the cover are free.

Figure 4-10 Opening the Memory Upgrade Compartment

C A U T I O N

The memory upgrade module can be severely damaged by electro-static discharge (ESD). Be sure you are properly grounded when handling and installing the module.

6.Remove the memory upgrade module from the static guarded sleeve.

U s e r I n s t a l l a b l e F e a t u r e s

7.Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade module with the connector slot in the compartment. The connector will be pointing toward the rear of the LifeBook.

8.Insert the memory upgrade module at a 45° angle. Press the connector edge of the module firmly down and into the connector until it lodges under the retaining clip. You will hear a click when it is prop- erly in place. (Figure 4-11)

Figure 4-11 Installing a Memory Upgrade Module

9.Replace the cover by hooking the tabs under the rear edge of the compartment opening and tilting down until flush with the bottom of your LifeBook.

10. Replace the screw.

P O I N T

The memory upgrade module is not something you routinely remove from your LifeBook. Once it is installed, you can leave it in place unless you want to increase system memory capacity.

REMOVING A MEMORY UPGRADE MODULE

1.Perform steps 1 through 5 of Installing a Memory Upgrade Module.

2.Pull the clips sideways away from each side of the memory upgrade module at the same time.

3.While holding the clips out, remove the module from the slot by lifting it up and pulling towards the rear of your LifeBook. (Figure 4-12)

Figure 4-12 Removing a Memory Upgrade Module

4.Store the memory upgrade module in a static guarded sleeve.

5.Replace the cover by following steps 9 and 10 of Installing a Memory Upgrade Module.