Installing Windows NT and Windows 2000
Perform the following steps to install Windows NT 4.0 or Windows 2000 on the drive that is attached to the IBM FAStT Host Adapter.
1.Insert the Windows NT or Windows 2000 setup diskette or insert the Windows NT or Windows 2000 installation CD into the
2.After the standard devices have been detected and configured, use the S option to Specify Additional Device.
3.Select Other; then, press Enter.
4.Insert the FAStT Host Adapter device driver diskette that you created in Chapter 4; then, press Enter.
5.Select QLogic QLA2200; then, press Enter.
6.Select the standard installation procedure.
Adding the Windows NT driver
Perform the following steps to add the Windows NT device driver to a previously installed Windows NT 4.0 system.
1.On your desktop, click My Computer → Control Panel → SCSI Adapters.
2.Click the Drivers tab and click Add.
3.Select QLogic from the list of manufacturers and click Have Disk.
4.Insert the IBM FAStT Host Adapter driver diskette you created for Windows NT. At the prompt type:
a:\nt
where a is the diskette drive letter. Click OK.
5.If you are installing the drivers from a
where z is the
6.Select IBM Netfinity QLA2200 PCI Fibre Channel Adapter and click OK.
7.Click Yes to restart your server so the driver settings can take effect now or click No to restart your system at a later time.