MS-7236 Mainboard
9.Press down the load lever lightly onto the load plate, and then se- cure the lever with the hook under retention tab.
11.Press the four hooks down to fas- ten the cooler. Then rotate the lock- ing switch (refer to the correct di- rection marked on it) to lock the hooks.
10.Align the holes on the mainboard with the heatsink. Push down the cooler until its four c lips get wedged into the holes of the mainboard.
12.Turn over the mainboard to con- firm that the
locking switch
Important
1.Check the information in H/W Monitor in BIOS (Chapter 3) for the CPU temperature.
2.Whenever CPU is not installed, always protect your CPU socket pin with the plastic cap covered (shown in step 1) to avoid damaging.