Fujitsu fi-4110CU manual For Safe Operation

Page 2

FOR SAFE OPERATION

Treatment of This Manual

Since this manual contains important information for using the fi-4110CU, read it thoroughly before using the product. Use the fi-4110CU only after thoroughly reading and understanding especially the section "Important Alert Messages" in this manual. Keep this manual handy, and store it carefully.

Notice to

Federal Communications Commission

American Users

Radio Frequency Interference Statement

 

This equipment has been tested and found to comply with the limits for a

 

Class B digital device, pursuant to Part 15 of FCC Rules. These limits are

 

designed to provide reasonable protection against harmful interference in a

 

residential installation. This equipment generates, uses, and can radiate

 

radio frequency energy and, if not installed and used in accordance with

 

the instructions, may cause harmful interference to radio communications.

 

However, there is no guarantee that interference will not occur in a

 

particular installation. If this equipment does cause harmful interference to

 

radio or television reception, which can be determined by turning the

 

equipment off and on, the user is encouraged to try to correct the

 

interference by one or more of the following measures:

 

· Adjust or relocate the receiving antenna.

 

· Increase the distance between the equipment and receiver.

 

· Connect the equipment into an outlet on a circuit different from the

 

circuit the receiver is connected to.

 

· Consult your dealer or an experienced radio/TV technician for help.

 

FCC warning: Changes or modifications not expressly approved by the

 

party responsible for compliance could void the user's authority to operate

 

the equipment.

Notes

·The use of a non-shielded interface cable with the referenced device is prohibited. The length of the parallel interface cable must be 3 meters (10 feet) or less. The length of the serial interface cable must be 15 meters (50 feet) or less.

·The length of the power cord must be 3 meters (10 feet) or less.

Fi-4110CU Image Scanner Operator’s Guide

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Fi-4110CU Image Scanner Operator’s Guide For Safe Operation Bescheinigung des Herstellers/Importeurs Trademark Acknowledgment Preface Important Notes to Users Conventions for Alert MessagesContents Regular Replacement Components 1 fi-4110CU Image Scanner Confirming the Content of Packing BoxOutline Component Names and Functions Fi-4110CU Image Scanner Operator’s Guide Internal Feed roller Eject roller Facing roller Installation and Connection Fire, electric shock, falling, or droppingMounting the Document Support Key pointConnection Connecting the Power Cable Confirming the System ConditionsConnecting to the Computer Installing the Device Driver and SoftwareSetting up the Stacker and Document Support Paper Extension Operation Before Scanning or Copying a Document Confirming Document Condition Setting Documents Scanning Documents Fi-4110CU Image Scanner Operator’s Guide Daily Maintenance Handling a Paper JamDaily Maintenance Cleaning Cleaning the Automatic Document FeederFi-4110CU Image Scanner Operator’s Guide Parts to be Cleaned on the Automatic Document Feeder Consumables and Regular Replacement Components Procedure for Replacing the Pad UnitProcedure for Replacing the Pick Roller Unit Paw Knob Pick Roller unit When you suspect that a fault occurred Fi-4110CU Image Scanner Operator’s Guide Installation Specifications Page Declaration of Conformity Fi-4110CU Image Scanner Operator’s Guide
Top Page Image Contents