Fujitsu fi-4110CU manual Setting Documents

Page 23

3.2.2 Setting Documents

This section explains how to set documents.

Loosening documents

Before setting documents, sufficiently loosen them by the following procedure:

·Remove a 4 mm thick section of pages, hold the ends of the documents with both hands, and bend the documents.

·Hold the documents strongly with both hands so that both ends of the documents are slanted, and then unbend the documents so that they are inflated.

·Repeat the operations described above two or three times.

·Turn the document by 90o and similarly loosen it.

uKey point

The thickness of the documents to be set shall be 4 mm or less. Failure to do so could result in the paper jam or the reading defect.

Leveling both ends and setting the documents

Level both ends of the documents so that they can be read correctly.

uKey point

Set the documents as follows:

For single-side reading: Place the reading side facing the document support surface.

For double-sided reading: Place the surface (first page) facing the document support surface.

3-4

fi-4110CU Image Scanner Operator’s Guide

Image 23
Contents Fi-4110CU Image Scanner Operator’s Guide For Safe Operation Bescheinigung des Herstellers/Importeurs Trademark Acknowledgment Preface Conventions for Alert Messages Important Notes to UsersContents Regular Replacement Components 1 fi-4110CU Image Scanner Confirming the Content of Packing BoxOutline Component Names and Functions Fi-4110CU Image Scanner Operator’s Guide Internal Feed roller Eject roller Facing roller Fire, electric shock, falling, or dropping Installation and ConnectionKey point Mounting the Document SupportConnection Confirming the System Conditions Connecting the Power CableInstalling the Device Driver and Software Connecting to the ComputerSetting up the Stacker and Document Support Paper Extension Operation Before Scanning or Copying a Document Confirming Document Condition Setting Documents Scanning Documents Fi-4110CU Image Scanner Operator’s Guide Handling a Paper Jam Daily MaintenanceDaily Maintenance Cleaning the Automatic Document Feeder CleaningFi-4110CU Image Scanner Operator’s Guide Parts to be Cleaned on the Automatic Document Feeder Procedure for Replacing the Pad Unit Consumables and Regular Replacement ComponentsProcedure for Replacing the Pick Roller Unit Paw Knob Pick Roller unit When you suspect that a fault occurred Fi-4110CU Image Scanner Operator’s Guide Installation Specifications Page Declaration of Conformity Fi-4110CU Image Scanner Operator’s Guide