Fujitsu fi-4990C manual Function Key F1 F2 F3 F1 selection Undefined Start key

Allocatable setup functions and other special functions					Remarks
Setup functions noted above
START key					START:	starts the operation stopped by
EJECT key						EJECT and sends data to the host
(Default: Undefined)						computer.
					EJECT:stops operation and ejects the paper in the
						transport unit.
The	F1 ,	F2 ,or	F3	button can be used as a shortcut key which enables you to access

the allocated setup function just by pressing the button whenever the scanner is in the Ready state. This function is valid even in the setup mode lock state (refer to the next function). However, the

F1	,	F2 , and F3	buttons are invalid in setup, browse, and test modes.
The following is an example of operation when you allocate START and EJECT keys to the				F1
and	F2	buttons respectively.

1.In <<SETUP MODE>> initial screen, press

ENTER .

The <<SETUP MODE>> menu screen (Paper Length Check) appears.

2.Press repeatedly until “Function Key” appears in the lower line of the menu screen.

3.Press ENTER .

The function key select screen appears with F1 blinking (blinking indicates “selectable”).

4.Press ENTER .

The F1 selection screen appears with the current setting Undefined blinking (blinking indicates “changeable”).

5.Press or .

The setup functions, START key, and EJECT key are displayed in sequence at the lower line.

<<SETUP MODE>>

<<SETUP MODE>> Paper Length Check

<<SETUP MODE>>

Function Key

Function Key

F1 F2 F3

F1 selection

Undefined

F1 selection

START key

6-41