Fujitsu 620C user manual Connecting the Cable, Turning the Power Off, Ii. Turning the Power On

Page 13

2.7 CONNECTING THE CABLE

i). Turning the Power Off

Depress the side marked “O” to turn the power off.

Connect the power cable and SCSI signal cable as shown in Figure 2-8 and Figure 2-9.

ii). Turning the Power On

Depress the side marked “I” to turn the power on. The POWER LEDwill light. If not, please

check the power source.

iii). SCSI Termination

The Fujitsu ScanPartner 620C comes complete with a built in SCSI terminator. If the Scanner is the last device in a SCSI chain the terminator should be switched on. If the Scanner is not the last device the terminator should be off. The terminator on/off switch is located on the back of the Scanner, to the left of the SCSI cable connectors.

Host PC

Term.

Scanner

SCSI Device

Term.

(Terminator Off)

Host PC

Scanner

Term.

(Terminator On)

2-9

Image 13

Contents ScanPartner 620C Image Scanner FCC Radio Frequency Interference Statement Table of Contents Scanner packing IntroductionRemoving the Shipping Bracket InstallationRemoving the Shipping Bracket Use Position Scsi Interface Device ID Refitting the Shipping BracketScsi Termination ADF Paper Chute Setting the ADF Paper ChuteADF Output Tray Install the ADF Output Paper TrayPlace Document on the Scanner Document LoadingUse ADF to Load Multiple Documents ADF ScanningTurning the Power Off Connecting the CableIi. Turning the Power On Iii. Scsi TerminationScanPartner 620C Scsi Cable Connection Cleaning the ADF MaintenanceOpening the ADF unit and Document Cover Procedures Cleaning the GlassReplacing the ADF SNAP-IN PAD Module Disassembling ProcedureInstalling the pad module Assembling ProcedureQuestion and Answer TroubleshootingPage ADF Paper Jam Opening the ADF Paper JAM in the ADFADF Paper Jam Removing the Paper Specifications SCSI-2 Scanpartner 620C SpecificationsIndex