2.1.2 REFITTING THE SHIPPING BRACKET
Whenever you need to move the Scanner to a new location it is advisable to refit the shipping bracket to avoid causing damage to the Scanners’ internal mechanism. Please follow the instructions below to refit the shipping bracket.
i). Turn off the Scanner power at the power on/off switch.
ii). Open the document cover.
iii). Turn off the Scanner.
Note: For steps (iv) to (vi) please refer to Figure
iv). Carefully place the Scanner in an upright position on its front side.
v). Use a suitable screwdriver to remove the screw holding the shipping bracket in the use position.
vi). Put the shipping bracket into the shipping position, with the long side extending into the Scanner base. Secure it with the screw.
vii). Carefully place the Scanner back into its normal position.
2.2 SCSI INTERFACE DEVICE ID
When you have several devices on a SCSI chain, you may need to adjust the SCSI ID selector setting located on the back of the Scanner. This setting assigns a specific "device ID" to the Scanner. If the assignment conflicts with an existing SCSI device, please select a new ID. (See Figure
Note: The factory setting for Scanner is ID 6. Usually, ID 0 is assigned to an internal hard disk drive, and ID 7, to SCSI adapter or host. ID 8 and 9 are not in actual use.
Using a suitable tool, turn the selector switch until the arrow points to the desired ID number.