IBM P09N4108 manual Reconnecting

The	device	driver	is	now	uninstalled.	Your	computer	will	not recognize the CD-ROM
drive	when	it	is	connected	to the	computer	unless	you	reinstall the device driver.

Disconnecting

and

reconnecting

the

CD-ROM

drive

Hot plugging

is

supported

on

the

connection

between

the

USB

cable

and

your

computer.

This

means

that

the

CD-ROM

drive

USB

cable

can

be

disconnected

from

and reconnected to your computer

whether

the

computer

is

on

or

off.

Attention

The

connection

between

the

USB

cable

and

the CD-ROM

drive

itself

does

not

support

hot

plugging.

If

you

disconnect

the

USB

cable

from

the

CD-ROM

drive

while

the

USB

cable

is

attached

to

your

computer,

it

might cause

damage to

the

CD-ROM

drive.

To avoid damaging the CD-ROM

drive,

turn

off

the

CD-ROM

drive

before

disconnecting the

USB

cable

from

your

computer.

To

disconnect

the

CD-ROM

drive

from

the

computer, unplug

the

USB cable

from

the

computer.

To

reconnect

the

CD-ROM

drive, reconnect the

USB

cable

to

the

computer.

Attention

Do

not

disconnect

and

reconnect

the

USB

cable

in

rapid

succession

or

the

CD-ROM

drive

might

not

load

properly.

After

disconnecting

the

USB

cable,

wait

at

least

10

to

20

seconds,

or

until

the

hourglass

icon

stops

displaying,

before

reconnecting

the

USB

cable.

1-6 USB Portable CD-ROM Drive