IBM P09N4108 manual See.3 Rear

Connecting

the

CD-ROM

drive

to

your

computer

Follow

these

instructions

to

connect

the

CD-ROM

drive.

1.

Locate

the

USB

cable

included

with

this

option.

One

connector

on

the

USB

cable

is

smaller

than

the

other

and

has

two small

buttons

on

each

side

of

it.

2.

Squeeze

the

two

buttons

on

the

smaller

connector

and

attach

that

end

of

the

USB

cable

to

the USB

connector

on

the

back of the

CD-ROM

drive,

as

shown

below.

Make

sure

that

the

metal

plate

on

the

smaller

connector

is

facing

up

when

you

plug

it

into

the

USB

connector

on

the

CD-ROM

drive.

3.

Plug

the

larger

end

of

the

USB

cable into

the

USB

port

on

your

computer.

4.

You

can

plug

a

set

of

headphones

into

the

audio

output

jack

(see.3/

in

the

rear

view

illustration

on page 1-8)

in

order

to

listen

to

audio

CDs. Alternatively, if

you

want

to

listen

to

audio

on

your

ThinkPad

speakers,

plug

one

end

of

the

included audio cable

into

the

audio

output

jack

on

the

CD-ROM

drive,

and

plug

the

other

end

of

the

audio

cable

into

either

the

microphone

jack or

the

line-in

jack

on

your ThinkPad computer. This will route

the

audio

to your

ThinkPad

speakers.

Installing	the	device	driver
To install the	device	driver, follow	the instructions that correspond to your operating
system.

Part 1: Installation and usage guide 1-9