IBM AC453A manual Computertop TV-III

COMPUTERTOP TV-III

2.Setup and installation of the Computertop TV-III software must be done at the DOS command level. Before attempting to install the Computertop TV-III software, you must exit Microsoft Windows. Do not exit Microsoft Windows by using the DOS icon.

3.Insert the Computertop TV-III setup disk in drive A:.

4.Type A:<CR>. A DOS prompt with drive letter A should be visible.

5.Type SETUP <CR> and follow the instructions.

6.Once software installation is complete, you can start Computertop TV-III operation by double-clicking on the Computertop TV-III icon. The cursor will change to an “hourglass” while the board is being initialized. When the cursor returns to normal, hit the SHIFT key, release it, then hit the CONTROL key and release it. In a few seconds, the Computertop TV-III video window will pop up.

8