ENGLISH
Adjusting the image settings in DOS
i If the monitor is in standby mode (STANDBY ON), it
may automatically turn off while you are waiting for it to warm up. If this happens, switch off the monitor and switch it on again after a few seconds.
i If you are using
change to U.S. mode by
typing ‘CHEV US’ and pressing
ENTER at the command prompt.
You must use when you run DOS Auto Setup.
i The size and diversity of the dot pattern varies with the
screen resolution.
i If the screen flickers, repeat the setup several
times until the flicker is minimised, or adjust it manually by following refer to
Manual Setup on page 12.
1. Turn on the monitor first; then the computer.
If the message CHECK VIDEO CABLE is displayed, or if nothing is displayed, check:
•that the video interface cable is not connected properly.
•the correct video adapter card is not installed.
2.Wait approximately 15 minutes, until the monitor warms up.
3.Insert the CD labelled ‘IBM Monitor CD’ into the CD drive.
4.Display the command prompt screen of the DOS
5.At the command prompt, type the CD drive letter, and press ENTER.
6.Type ‘TESTPATD’ and press ENTER.
7.Select from the screen the number for the color or text mode you want to setup.
8.Select from the screen the number for the video mode you want to setup.
You may repeat this process for as many of the color and video modes as you need.
9.When the test pattern appears, press the Image Setup direct access
button 
at the bottom of the monitor to run the image setup.
10.To clear the Image Setup test pattern, press the ESC key on your keybord.
11.Type ‘Exit’ at the command prompt to return to Windows.
If you use other operating systems, perform the appropriate Image Setup for those systems and also see
Image Setup Windows 3.1, Windows 95, Windows 98, Windows 2000, Windows Me, Window XP or Windows NT workstation on page 10.
11