Automatic Image Setup
ENGLISH
Image Setup ( 
)
The Setup Utility included on the installation
CD is for displaying dot patterns. They do not replace or modify the display driver.
The Image Setup ( 
) instructions require the monitor to warm up for 15 minutes. This is not required for normal operation.
By pressing the Auto key, you will have direct access to Automatic Image Setup Adjustment.
When you first use your monitor you must perform Image Setup ( 
). This procedure sets up your monitor to process the video signals from your computer without image discoloration or smearing. After you perform Image Setup ( 
), the settings are stored and used each time you turn on the monitor.
To optimize the displayed image a 
) for each operating system that you use. This means that if you use your monitor while running any version of Windows and also use it from within DOS (not a DOS window), you must run IMAGE SETUP ( 
) for both Windows and DOS. You can run versions of IMAGE SETUP ( 
) in any order.
FRANÇAIS
ESPAÑOL
The IMAGE SETUP ( 
)
process only applies to the current screen mode. When a new mode is selected, repeat this section to reset the monitor.
Operating System | Corresponding Image Setup Procedure |
|
|
|
|
DOS | Image Setup ( ) for DOS on page 12 |
|
|
Windows 95, Windows 98, | Image Setup ( ) for Windows 95, Windows 98, |
Windows 2000, | |
Microsoft Windows NT®, | Windows NT, Windows 2000, Windows ME, |
Windows XP on page 13 | |
Windows Me or Windows XP |
|
|
|
Before you begin IMAGE SETUP ( 
) for your computer:
1.Make sure the computer’s video mode is set in the range of the supported screen resolution shown in the table on page 20.
You should perform IMAGE SETUP ( 
) for each screen mode you use.
COMPL & WARR JAPANESE ITALIANO
11