Manual Image Setup
If the monitor is in sleep mode, it might automatically
turn off while you are waiting for it to warm up.
Normally, you can complete the setup procedure using IMAGE SETUP ( 
); however, if your screen image is still distorted after you perform IMAGE SETUP ( 
) or the User’s Guide and Installation CD does not run on your system,
perform MANUAL SETUP.
1.Have your monitor turned on for about 15 minutes, until the monitor warms up.
2.Display the image you most frequently use on the screen.
3.Press the OSD Enter button 
at the bottom of the bezel to display the initial OSD menu.
4.Use the 
button to select the Image Setup icon ( 
) and press the
OSD Enter button 
to access.
5.Use the 
button to select Manual. Press Enter and Clock becomes highlighted. Press Enter again and adjust the screen quality settings. Press Enter twice to select Phase, the right arrow icon, and then Enter again to select phase. Adjust Phase, then press Enter twice to save and
6.Press the Exit (
) button to exit Image Setup.
You have completed monitor setup.
14